Intergrain UltraPrep Tannin & Oil Remover (previously known as PowerPrep) allows you to coat new bare timber immediately. UltraPrep Tannin & Oil Remover also removes old or weathered existing timber finishes.
Coverage: 5m2/L
Fully Cured: N/A
Clean up: Water
Sheen: N/A
Sizes: 1L, 4L, 10L
Water wash up
High strength remover
Always follow with UltraPrep Timber Cleaner
Areas: New exterior timber, exterior timber with worn patchy coatings
Substrates: All exterior timber
Locations: Exterior
Remove surface dirt by sweeping or washing down with water.
Methods: brush, spray, Applicator
1. Remove surface dirt by sweeping or washing down with water.
2. Shake UltraPrep Tannin & Oil Remover thoroughly.
3. Wet the timber surfaces to be cleaned with water.
4. Apply UltraPrep Tannin & Oil Remover undiluted to the timber with a stiff bristle brush, broom, or spray. Clean complete sections at one time. Spot cleaning should be avoided to prevent patchy results.
Note: UltraPrep Tannin & Oil Remover is very slippery. Take care when walking on treated surface.
5. Leave UltraPrep Tannin & Oil Remover on the timber for 10–15 minutes. If necessary, apply more UltraPrep Tannin & Oil Remover to keep timber damp throughout this period. Do not allow UltraPrep Tannin & Oil Remover to dry on the surface.
6. For best results UltraPrep Tannin & Oil Remover should be applied to cool surfaces, out of direct sunlight, to avoid the cleaner drying on the timber.
7. Scrub the timber vigorously with a stiff broom. Do not use a wire brush.
8. Rinse off exterior surfaces thoroughly using maximum pressure from a garden hose or using a high pressure water cleaner. For best results, a high pressure water cleaner is recommended.
IMPORTANT: Failure to thoroughly remove UltraPrep Tannin & Oil Remover may result in timber discolouration under clear finishes.
9. If stubborn areas remain, repeat application in those areas as per the instructions above.
10. Rinse off exterior surfaces thoroughly, then clean timber with UltraPrep Timber Cleaner closely following label instructions. Note: After cleaning with UltraPrep Tannin & Oil Remover, some timber species will appear darker. UltraPrep Timber Cleaner will restore brightness.
11. Allow timber to dry thoroughly before applying further products.